Taifun GT 2 Cotton Coil Tutorial

e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/3138053449_I0ZktWZ.jpg” target=”_blank” rel=”nofollow”>e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/3138053449_I0ZktWZ.jpg” class=”bbCodeImage LbImage” alt=”[​IMG]” data-url=”http://e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/3138053449_I0ZktWZ.jpg” />
Tools: * Phillips screwdriver * Ohm meter * pre-build dia. .4mm coil * Allen key for adjusting the coil position * Japanese organic cotton
e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/9267edcef9_Ic9lU7s.jpg” target=”_blank” rel=”nofollow”>e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/9267edcef9_Ic9lU7s.jpg” class=”bbCodeImage LbImage” alt=”[​IMG]” data-url=”http://e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/9267edcef9_Ic9lU7s.jpg” />e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/afd8d8e393_a2ujKXg.jpg” target=”_blank” rel=”nofollow”>e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/afd8d8e393_a2ujKXg.jpg” class=”bbCodeImage LbImage” alt=”[​IMG]” data-url=”http://e-cigkissimmee.com/wp-content/plugins/wp-o-matic/cache/afd8d8e393_a2ujKXg.jpg” />
install the coil…

Taifun GT 2 Cotton Coil Tutorial

Vaping Life Hack for Tank Holders

All it will cost you is a bottle of water, which you should be drinking anyway!

Only works with Dasani! e-cigarette-forum.com/forum/forums/tips-and-tricks.19/styles/default/xenforo/clear.png” class=”mceSmilieSprite mceSmilie13″ alt=”:)” title=”Smile :)” />

Hope this helps you save some cash!

Using beverage heaters for "speed steeping"

I'm using one of those desktop coffee cup "beverage warmers" to warm my diy juice and speed ageing. I place a beaker of water directly on the hot surface and then put the juice bottle directly in the water. Warms it up nicely and seems to make the juice taste better in a short amount of time. I stir it periodically (manually).

Has anyone else tried this, and can you report your success/failure or suggest other tips?

Cheers

New here but.. 20 Awg. wrapped in .05x.1 ribbon is gooood.

All A1 Kanthal, 6 wraps around a .133 drill bit. 0.143 ohms.

Barely but perfectly fits in my mad hatter with .084" side holes drilled, aimed downwards at about 45 degrees. Huge clouds and perfect flavor, flavor is up there with a standard Clapton, but the wattage is less and ramp up is less and clouds are bigger. BTW I am not sure where the sweet spot is I just made these, but I'm going between 115-130 watts. It's my favorite coil so far and I've made quite a few.

I started with a…

New here but.. 20 Awg. wrapped in .05x.1 ribbon is gooood.

Proudly powered by WordPress
Theme: Esquire by Matthew Buchanan.